Henan Mikim Machinery Co., Ltd.
Henan Mikim Machinery Co., Ltd.
Add to Cart
Factory Hot Sale Stainless Steel Heat Exchanger Gas Water Heater Shell And Tubes Exchanger
Description
The shell and tube heat exchanger is sealed and equipped with a pressure spring as an automatic compensation device for thermal expansion and contraction. Two sets of disjoint flow channels are drilled on the graphite block, and the two groups form a right angle, and two different fluids pass through the two sets of flow channels to achieve the purpose of heat exchange. The processing technology adopted by the system has the advantages of high heat transfer efficiency, stability and reliability, impact resistance and convenient maintenance. The large heat exchange area can reach 800 square meters.
Parameter
| shell and tube heat exchanger | |
| Profile type | Tuber exchanger |
| Material | SS304 or SS316L |
| Capacity | 0.1T/H-100T/H (Customized) |
| Working pressure | 0.8Mpa(Customized) |
| Heating Area/Cooling Area | 0.1~20M2 |
| The Diameter of Pipe | Φ6/Φ9/Φ12/Φ16/Φ19/Φ25mm |
| Inlet Outlet | Φ19~ Φ219mm |
Technical Parameters:
A Shell-and-tube heat exchanger products are made of Φ9, Φ6, Φ5, Φ4, Φ3 and other tube bundles and flanges arranged in honeycomb holes and welded as a whole. The protective frame is made of corrosion-resistant PP pure plate, so that the tube bundle is shaped and positioned, which is convenient Easy to use and install, clean and beautiful, the interface is stainless steel (304,316) flange type or PP, PVC joint. Use steam (heat transfer oil or hot water) to heat; use cooling water (groundwater, tap water, well water, chilled water) to cool down.
b. Product temperature range: -150～260℃; Working pressure: Steam≤0.5Mpa; Refrigerant≤1.5Mpa.
c. Using capillary heating, the surface wall is thin, the surface is not sticky, the diameter is small, the pressure resistance is high, and the temperature resistance and softness are good.
d. Product quality inspection: in a closed-circuit system, the saturated steam is 0.3Mpa for 1 hour; the cold-pressed single tube is 1.4Mpa for 8 hours; welding strength: >50N/piece.
